With the coming of high temperature in summer, many laser cutting machines will generate a lot of heat during work, which will cause some failures. Therefore, when using the laser cutting machine in summer, it is necessary to pay attention to the cooling preparation of the equipment. In high temperature conditions, people will suffer from heatstroke, and machinery is no exception. Only by doing a good job of preventing heatstroke and maintaining the laser cutting machine can the service life of the equipment be extended.
Water cooling equipment
The water cooler is the necessary cooling equipment for the laser cutting machine. In the high temperature environment, the cooling liquid deteriorates quickly. It is recommended to use distilled water and pure water as the cooling liquid. During use, it is necessary to regularly clean the scale attached to the laser and the pipeline, so as to prevent the accumulation of scale from causing the blockage of the coolant and affecting the cooling of the laser. The water temperature of the cooling liquid should not be too different from the room temperature, so as to avoid condensation due to the large temperature difference. As the temperature gradually increases in summer, the working pressure of the cooling system of the laser cutting machine will increase sharply. It is recommended to check and maintain the internal pressure of the cooling machine before the high temperature comes. , timely adjustment to adapt to high temperature weather.
Lubrication treatment
The transmission parts need to be wiped and removed frequently to ensure that the equipment is clean and clean, so that the equipment can run more smoothly. Lubricating oil needs to be filled between the guide rails and gears. The filling time interval should be adjusted, which is about twice as short as that in spring and autumn. And often observe the oil quality. For machinery working in high-temperature areas, the viscosity grade of the oil should be appropriately increased. The temperature of grease oil is easy to change, so it should be properly refueled to ensure lubrication without debris. Carefully check the straightness of the cutting table and track of the laser cutting machine and the verticality of the machine, and maintain and debug in time if any abnormality is found.
Line check
Check and replace worn wires, plugs, hoses and fittings. Check whether the pins and wires of the connectors of electrical components are loose, and tighten them in time to avoid electrical burnout and unstable signal transmission caused by poor contact.
The equipment has a certain loss when it is used, especially when the high temperature summer is coming, only by protecting the laser cutting machine and keeping it in good condition at all times can it bring greater benefits to itself.